6-18
Indmar Marine Engines
TRANSMISSION MODEL CAPACITY FLUID TYPE
ZF Hurth In-Line ZF 45C 1.7 qt (1.6 L) Dexron ATF
ZF Hurth In-Line ZF 45A 2.12 qt (2 L) 15W40 Motor Oil
ZF Hurth In-Line ZF 63A 4.2 qt (4 L) 15W40 Motor Oil
ZF Hurth V-Drive ZF 63IV 4.2 qt (4 L) 15W40 Motor Oil
ZF Hurth V-Drive ZF 45IV
2.12 qt (2 L) Main Gearbox Dexron ATF
1.0 qt (1.06 L) V-Drive Unit Dexron ATF
Walters V-Drive RV-26D-71V 0.5 qt (0.5 L) 15W40 Motor Oil
Indmar V –
2.3 qt (2.18 L) Main Gearbox Dexron ATF
1.25 qt (1.18 L) V-Drive Unit Mobil Delvac Synthetic 50
Check fluid immediately after turning the engine “OFF”
and boat floating level, or level on trailer. The transmission
dipstick is located on the top of the transmission. Dipsticks
may be marked “ADD” and “FULL” or “H” and “L” (high
and low); maintain fluid level between the two marks.
1. Remove the dipstick and wipe with a clean towel.
2. Insert the dipstick completely (do not screw in threaded
dipstick to check fluid). Remove the dipstick and read
fluid level.
3. Return dipstick after level check. Make sure it is
secured in place.
4. If level is below “ADD” mark, add the proper fluid until it
reaches the full mark. Add fluid through same tube as
you removed the transmission dipstick.
NOTICE
Do not overfill the transmission. Overfilling can damage
the transmission. Damage to your transmission due to too
much or too little fluid is not covered by your warranty.
OME0502-15 Body.qxp_OM0502-05 Body.qxd 5/20/14 12:45 PM Page 6-18
To Next Page
Loading...
Need help?
General