Charging Cable Stowage
Tethered Variants (190105A101 & 190105A102)
• Disconnect the Smart PRO’s connector from your EV.
Seek car manufacturer guidance on how to do so, as this is often EV specic
(Nissan Leaf disconnection is via the EV’s key fob for example)
• Coil the long charging cable around the circumference of the Smart PRO
enclosure, several times, leaving a very short tail.
• Push the male charging connector into the blank holster recess of the
Smart PRO unit, so that it clips/ latches into position and is held.
• Ensure that no part of the coiled charging lead is trailing on or close to
the ground.
Socketed Variant (190105A103)
• Disconnect the Smart PRO from your EV.
Seek car manufacturer guidance on how to do so, as this is often EV specic
(Nissan Leaf disconnection is via the EV’s key fob for example)
• Remove your charging cable connector from the EV socket FIRST.
• Completely detach your charging cable from the Smart PRO unit by rst
pushing gently inwards towards the rear of the charger unit (this removes any
pressure from the locking pin, allowing it to retract fully).
• Secondly, carefully pull downwards on your charging cable connector to remove
it from the Smart PRO device.
• Coil and stow this loose cable somewhere secure, and where it won’t
create a trip hazard.
NOTE: APPROPRIATE CHARGING CABLE STOWAGE IS ESSENTIAL TO PREVENT
INADVERTANT TRIPS/ FALLS OR DAMAGE TO THE EV CONNECTOR
12 Indra Smart PRO
User Guide
To Next Page
Loading...
