EasyManua.ls Logo

INDU+ IDP401Z - Automatic Cooking; Stop&Go Function; Recall Function

Default Icon
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
66
Automatic cooking
All the cooking zones are equipped with an automatic cooking device. The cooking zone starts at
full power for a certain amount of time, then automatically reduces its power until it reaches the
pre-selected power level.
Start-up:
Action Control panel Display
Power level selection slide on the “SLIDER“ to [ 7 ] [ 7 ] is blinking with [ A ]
(for example « 7 ») and stay 3s
Switching off the automatic cooking:
Action Control panel Display
Power level selection slide on the “SLIDER“ [ 0 ] to [ 9 ]
Stop&Go function
This function temporarily puts an end to the hob’s entire cooking activity, and allows restarting
with the same settings.
Start up/stop the stop&go function:
Action Control panel Display
Engage stop&go press [ II ] [ II ] and control light on
Stop stop&go press [ II ] “Slider” animated
Press on the animated “slider” previous settings
Recall Function
After switching off the hob [ 0/I ], it is possible to recall the last settings.
cooking stages of all cooking zones (Booster)
minutes and seconds of programmed cooking zone-related timers
Keep warm function
Automatic cooking
The recall procedure is the following:
Press the key [ 0/I ]
Then press [ II ] before the light stops blinking.
The previous settings are activated again.

Table of Contents