12 – Inepro Metering – PRO Series
6 Operation
6.1 Energy flow indication
The red LED on the front panel indicates the power flow measured by the meter. When power flows,
the LED will flash. The faster the LED flashes, the more power flows. For this meter, the LED will flash
10.000 times per kWh. The first display indication of the meter in the scrolling mode is either FW
(forward) or RV (reverse)
6.2 Re-active energy indication
The dispay will show Kvarh to indicate the meter is measuring re-active energy.
6.3 Tariff indication
The LCD will show either the symbol T1 or T2 in the LCD for the active tariff.
6.4 Reading the meter
Two red LED’s on the front panel indicates the consumption measured by the meter, one for active and
one for reactive energy. When power is consumed, the LED will flash. The faster the LED flashes, the
more power is consumed. For this meter, the LED will flash 10.000 times per kW.
The meter is equipped with a 8 digit LCD. For the energy consumption the meter will display 999999.99
kWh.
6.5 LCD display of the meter
The LCD is a multifunctional display, it has two rows to indicate the status of the meter. The top row
shows the value, while the bottom row shows the units, phase and/or direction.
After power on the first display to be shown is
This page indicates per phase the direction of the energy. In this picture phase 1 is reverse and phase
2 and 3 are forward.
The following pages are available under the buttons, but can also be set in a scrolling mode on the LCD.
For changing the displayed pages in scrolling mode, please see our IR manual.
To Next Page
Loading...
