iNetVu 7000 Series Instruction Manual

INETVU® MOBILE SYSTEM QUICK START – BEACON RECEIVER BR300L
C-COM Satellite Systems Inc. Page 10
6. Set the 7000 Controller to the same network as the PC and VSAT Modem.
*Note: The controller IP should be set in the controller through the LCD interface prior to entering
it into the software tool for proper PC to Controller Communication through network interface.
(USB Interface users may skip this step)
To Configure the IP address on the controller, you must navigate to the CONF2 menu using the LCD
Interface. (Default password “password”)
a. Navigate to the “IP” menu and press the “ENTER” button.
b. Press the ‘↑’ button to allow for modification on the C_IP field and set the IP address of the controller.
For example, if the Modem/Router IP is 192.168.0.1 then the controller IP could be set to 192.168.0.2.
Press the “ENTER” button once the change is complete.
c. Press the “Exit” button twice to exit out of the configuration menu. When prompted if you would like to
save configuration, press the ‘↑’ button to select “Y” (yes) and press “Enter”.
d. Click the “reset” button on the controller.
You may view the 7000 Controller IP from the LCD interface via – MONITOR  IP (C_IP)
S2 MB EL AZ PL GP
C1 C2 C3 DS SG IP SR
C_IP: 192.168.000.002
M_IP: 192.168.000.001

iNetVu 7000 Series Specifications

General

Brand	iNetVu
Model	7000 Series
Category	Controller
Language	English