iNetVu 7000 Series Instruction Manual

INETVU® MOBILE SYSTEM QUICK START – BEACON RECEIVER BR300L
C-COM Satellite Systems Inc. Page 9
1.9 Software Setup and Initial Configuration Procedure with BR300L
1. Power ON your PC/Notebook, 7000 Controller and install the iNetVu® 7000 Mobile Software
from the installation CD/USB Drive. For USB interface please install correct USB drivers and skip
to step (8).
2. If you are using the network interface to communicate with the 7000 Controller, set the
PC/Notebook to the same network as the 7000 Controller. (If you are using the USB interface,
you may skip to step (8).
3. Open Network and Sharing Center\Network
Connections, right-click your network card, and select
Properties.
4. Select Internet Protocol Version 4 (TCP/IPv4) and click
Properties.
5. Select Use the following IP address.
Set your PC to the same subnet as the 7000 Controller.
IP Address: A.B.C.D+2
Subnet Mask: 255.255.255.0
Gateway: A.B.C.D (Modem/Router IP)
The Gateway is usually the Router IP address. If no router is used, it is
usually the VSAT Modem IP Address.
Set the DNS IP Addresses if required.

iNetVu 7000 Series Specifications

General

Brand	iNetVu
Model	7000 Series
Category	Controller
Language	English