Infineon SP37 - Code Example; Figure 3 Code Example for Usage of Meas_Pressure()

SP37
Tire Pressure Monitoring Sensor
ROM Library Functions
ROM Library Function Guide 41 Revision 1.0, 2011-12-15
2.2.9 Code Example
Figure 3 Code example for usage of Meas_Pressure()
// Library function prototypes
#include "SP37_ROMLibrary.h"
void main()
{
// Return value of pressure measurement is stored in StatusByte
unsigned char StatusByte;
// Input parameters for pressure measurement
// Configure register to perform a 2-sample pressure measurement
// Automatic Range Selection
unsigned int SensorConfig = 0x0481;
unsigned char SampRate = 0x00;
// struct for pressure measurement results
struct{
signed int Pressure;
signed int Raw_pressure;
signed int Raw_temperature;
} idata Press_Result;
// Pressure measurement function call
StatusByte = Meas_Pressure(SensorConfig, SampRate, &Press_Result.Pressure);
if(!StatusByte)
{
// Pressure measurement was successful
}
else
{
// Pressure measurement was not successful, underflow or
// overflow of ADC result, Sensor Fault Wire Bond Check,
// or VMIN warning occurred
}
}