Infineon TRAVEO T2G - Getting Started: Before You Start; Getting Started: Powering Up; Getting Started: Running the Code Example; Getting Started: Next Steps

Quick Start Guide
Page 2 of 4
1
Power up the kit
Before you start
1. Ensure that you have the following:
– PC with USB Port
– UART terminal soware such as Tera Term
or Minicom
Powering up the kit
1. Connect the USB micro-B cable to J2 and other end to PC
Run the pre-programmed code example
1. Open the UART terminal soware and connect to the kit’s
USB-to-UART COM port with the following settings:
– Baud rate: 115200, Data: 8 bit, Parity: none
– Stop bit: 1 bit, Flow control: none
2. Press the RESET button (SW2) on the kit.
3. The states of various interface tests will be displayed on
the serial terminal as shown.
4. The User LEDs LED3, LED4, LED5 will blink continuously.
Next steps
Visit the kit webpage for required soware, information
on code examples supported for this kit and
kit documentation
Note:
The contents on the serial terminal may vary because
of continuous improvements.
2
Run the shipping firmware