Infineon TRAVEO T2G - TRAVEOTM T2 G Body High Lite Kit Board Overview; Shield2 Go Connectors; mikroBUS Connectors; 32.768-kHz Oscillator

Quick Start Guide
Page 3 of 4
TRAVEO
TM
T2G Body High Lite Kit Board details
1 Shield2Go connectors (not mounted) (J7, J19)
2 mikroBUS connectors (J11, J12)
3 32.768-kHz oscillator for WCO (Y1)
4 16-MHz oscillator for ECO (Y2)
5 Ethernet physical layer (PHY) transceiver (U11)
6 RJ45 Ethernet connector (J6)
7 TRAVEO™ T2G microcontroller (U6)
8 8-pin Arduino header (J13)
9 Expansion header 1 (X1)
10 6-pin Arduino header (J15)
11 DC power jack (J1)
12 Input power supply selection jumper
(J25) - default closed (1-2)
13 Power LED (LED2)
14 KitProg3 USB micro-B connector (J2)
15 VDD current measurement jumper (J20)
16 5V Supply Enable jumper (J22) - default closed
17 MIPI10/20 debug connector (J4)
18 KitProg3 status LED (LED1)
19 PSoC™ 5LP based KitProg3 (U4)
20 Mode switch (SW1)
21 VDDIO current measurement jumper (J21)
22 8-pin Arduino header (J14)
23 Potentiometer (VR1)
24 USER LED (LED)
25 USER LED2 (LED4)
26 USER LED1 (LED3)
27 Expansion header 2 (X2)
28 10-pin Arduino header (J16)
29 CAN FD transceiver (U8)
30 CAN FD connector (J5)
31 USER2 button (SW4)
32 USER1 button (SW3)
33 RESET button (SW2)
34 25-MHz crystal for Ethernet transceiver (Y3)
1
2
1
3
4 765 8 9 10
11
12
13
14
15
16
17
19
18
20
21
22
23
24
25262728293031
323334