Need help?Do you have a question about the Infineon TRAVEO T2G and is the answer not in the manual?
General| Series | TRAVEO T2G |
|---|---|
| Category | Microcontroller |
| Flash Memory | Up to 8 MB |
| ADC Resolution | 12-bit |
| DAC Resolution | 12-bit |
| Operating Temperature | -40°C to +125°C |
| Core | ARM Cortex-M4F / M7 |
| Communication Interfaces | CAN FD, Ethernet, SPI, I2C, UART |
| Security Features | Secure Boot |
| Automotive Grade | AEC-Q100 |
| Package | LQFP, BGA |
Shield2Go connectors for expansion, not mounted (J7, J19).
mikroBUS connectors for add-on modules (J11, J12).
Dedicated oscillator for WCO (Y1).
Dedicated oscillator for ECO (Y2).
Physical layer transceiver for Ethernet communication (U11).
Standard RJ45 port for network connection (J6).
The main TRAVEO T2G microcontroller unit (U6).
Two 8-pin headers for Arduino compatibility (J13, J14).
Headers for board expansion (X1, X2).
Additional 6-pin header for Arduino compatibility (J15).
Input for external DC power supply (J1).
Jumper for selecting input power source (J25).
Indicator LED for power status (LED2).
USB connector for KitProg3 programmer (J2).
Jumper for measuring VDD current (J20).
Jumper to enable 5V supply (J22).
Connector for MIPI/20 debugging interface (J4).
Status indicator LED for KitProg3 (LED1).
On-board KitProg3 programmer (U4).
Switch for selecting operation mode (SW1).
Jumper for VDDIO current measurement (J21).
Adjustable component for variable input (VR1).
User-controllable LEDs (LED3, LED4, LED5).
User-operable buttons for input (SW3, SW4).
Button to reset the microcontroller (SW2).
Crystal for Ethernet transceiver frequency (Y3).
To Next Page
