Infineon TRAVEO T2G Getting Started

User Guide Please read the Important Notice and Warnings at the end of this document 002-32910 Rev. *A
www.infineon.com page 1 of 25 2021-09-29
Getting started with TRAVEO™ T2G entry family
starter kit
About this document
Scope and purpose
This document explains how to set up and use TRAVEO™ T2G body entry family starter kit. The document also
explains how to debug with a single core and dual core environment in IAR embedded workbench for Arm®
(EWARM). The document uses the TRAVEO™ T2G body entry starter kit board with the sample driver library
(SDL).
Intended audience
This document is intended for software and hardware engineers integrating TRAVEO™ T2G body entry device
into their application.
Abbreviations and definitions
Table 1 Abbreviations
Abbreviations
Description
CM0+
Arm® Cortex®-M0 plus
CM4
Arm® Cortex®-M4
SDL
sample driver library
SK
starter kit
USB
universal serial bus
EWARM
embedded workbench for Arm®
C-SPY
high level debugger language for embedded system
Reference documents
[1] KitProg3 user guide
[2] TRAVEO™ T2G starter kit user guide

Infineon TRAVEO T2G Specifications

General

Series	TRAVEO T2G
Category	Microcontroller
Flash Memory	Up to 8 MB
ADC Resolution	12-bit
DAC Resolution	12-bit
Operating Temperature	-40°C to +125°C
Core	ARM Cortex-M4F / M7
Communication Interfaces	CAN FD, Ethernet, SPI, I2C, UART
Security Features	Secure Boot
Automotive Grade	AEC-Q100
Package	LQFP, BGA