Infineon TRAVEO T2G - SDL and IAR EWARM Setup; SDL Environment Setup; IAR EWARM Setup

User Guide 6 of 25 002-32910 Rev. *A
2021-09-29
Getting started with TRAVEO™ T2G entry family starter kit
SDL and IAR EWARM setup
2 SDL and IAR EWARM setup
This section explains how to run an example from the SDL on the TRAVEO™ T2G starter kit using the IAR C-SPY
debugger.
2.1 SDL environment setup
Download the latest SDL for the TRAVEO™ T2G starter kit on the target system. Install the SDL outside the
default program files to allow the IDE to access and create temporary files. Figure 4 shows the sample path.
Figure 4 SDL 7.0.0 top-level directory
2.2 IAR EWARM setup
Open the Readme.pdf from the root folder of the SDL and use the same link to download the version of IAR
EWARM supported by the SDL.
Download the software and run the installation (note that the installation might take some time). When you
open the IAR EWARM for the first time, select the license in the License wizard. If you do not have the license, it
is strongly recommended to register for a Code size limited license type. See Figure 5.
Note: IAR EWARM v8.42.1 is only for reference; always use the IAR EWARM version supported by the
specific SDL release.