Infineon TRAVEO T2G - Debugging with Single Core CM0+ Workspace

User Guide 10 of 25 002-32910 Rev. *A
2021-09-29
Getting started with TRAVEO™ T2G entry family starter kit
Download and debug with starter kit
3.1 Debugging with single core CM0+ workspace
1. Start IAR EWARM and open the SDL template workspace file:
tviibe1m\tools\iar\flash\tviibe1m_flash_cm0plus_template
Figure 8 Selecting CM0+ single core template
2. Select the workspace revision starter_kit from the drop-down list under Workspace, as shown in
Figure 9.
Note: Ignore other workspace revisions for this starter kit. The other revisions constitute the MCU
assembled on other evaluation boards (CPU board).