User Guide 3 of 25 002-32910 Rev. *A
2021-09-29
Getting started with TRAVEO™ T2G entry family starter kit
1 Getting started
This section explains the hardware setup. Table 2 lists the prerequisites for the setup.
Table 2 Prerequisites
TRAVEO™ T2G body entry series starter kit
For power and communication
Sample driver library v7.0.0
1.1 Connection setup
Connect the USB cable from the PC to the starter kit. The starter kit is powered by the PC via the USB cable
(5 V). Check if the mode LED (LED3) and the power LED (LED2) are turned ON.
Figure 1 Connection between PC and starter kit
1.2 Power up
When powered ON, the device will start executing the pre-installed firmware, which is indicated by the blinking
user LEDs (LED1 is controlled by core Arm® Cortex®-M0+ (CM0+) and LED4 is controlled by core Cortex®-M4
(CM4)).
To Next Page
Loading...
