Infineon XENSIV DEMO SENSE2GOL - Page 24

User manual
24
Revision 1.40
2023-02-14
24 GHz radar tools and development environment
XENSIV™ 24 GHz radar demo boards
4 Extracting radar raw data
A coding example to interface with the 24 GHz radar board via MATLAB and extract raw data is available. (Refer
to the extract_raw_data.m file.) In order to run this coding example, proceed as follows:
• Go to /Firmware_Software/Communication Library/ComLib_Matlab_Interface
/RadarSystemExamples/GettingStarted folder and copy the path.
• Open MATLAB, then paste the path into the top tab, and the “extract_raw_data.m” file will show up on the
left tab.
• Ensure that your 24 GHz radar board is connected, then click on Run to see the raw data.
Figure 32 MATLAB radar system interface
Figure 33 shows the example running on MATLAB, extracting raw data from the DEMO DISTANCE2GO radar
board.
Figure 33 Raw data acquisition in MATLAB command window