Infinity 54000 - Using the Controller; Resetting the Bed

18
Using the Controller
The UP arrow ( ) indicates raising the corresponding parts of the bed.
The DOWN arrow ( ) indicates lowering the corresponding parts of the bed.
1. Use button □
1
and □
2
to adjust the backrest up or down.
2. Use button □
3
and □
4
to adjust the kneebreak up or down.
3. Use button □
5
and □
6
to simultaneously adjust the backrest
and kneebreak up or down (Auto-Contour).
4. Use button □
7
and □
8
to raise or lower the bed platform.
5. Use button
□
9 to put the bed into chair position.
6. Use button
□
10 to put the bed into flat position.
7. Use button
□
11 to turn on/off the underbed lighting.
8. Use button
□
12 to engage in electronic CPR lowering.
Resetting the Bed
Where a connection fault is identified and rectified, the control system will require a
reset in order to operate again.
1. Press and hold the control button for lowering the backrest and
kneebreak. Continue to hold down the button for 10 seconds after the
mattress platform is completely flat.
2. Press and hold the control button for raising the mattress platfrom.
Continue to hold down the button for 10 seconds after the mattress
platform reaches the highest position.
1
2
3
4
5
6
7
8
9
10
12
11