3
PRELUDE MTS
Please read through this owner’s manual completely before
attempting to install or connect the speakers.We understand that
you may be anxious to play your new system,so we have made
every effort to simplify the installation and connections of the
Prelude MTS.However,there are still several times when you will
be asked to make a hookup or adjustment decision based upon
the details of your particular system and listening room.Your
patience will be rewarded with a loudspeaker system that is
optimized to your particular listening room in order to deliver
the best performance possible.
Before proceeding,you should decide how you would like to install
the tower portion of the Prelude MTS system.The tower may only
be attached to the powered subwoofer,mounted to our optional
floor stands,or mounted on the wall using the optional wall
brackets.In all cases,it is strongly recommended that two or three
people install the tower to minimize the possibility of damage or
injury.
Installing Feet
Refer to Figure B as you perform the following steps:
1.Open each accessory pack and locate the following items:feet
(with spike/round ends),four locking nuts,four nylon domes and
one wrench.
2.Lay each speaker on its side and locate the two threaded holes
on the bottom.
3.For carpets,screw the round end of a foot into each hole and
fully hand-tighten a nut onto each one.For hard-surface floors,
screw the spike end into each hole instead and leave the
rounded end exposed.
4.Carefully flip each speaker upright to sit on its feet.
5.If needed,adjust the feet so each speaker is level and then
tighten each nut with the enclosed wrench.To protect hard surfaces
(e.g.,wood floors),slip a nylon dome onto each round end.
Note: Spiked feet must be fully threaded into holes provided in
base to ensure stability.
STEP 1
To Next Page
Loading...
Need help?
General
