Copyright ©2021, Infoblox, Inc. All rights reserved.
CC and FIPS Compliance for 2205 Series Appliances
Infoblox 2205 series appliances can be made compliant with CC and FIPS 140-2 security standards. For the list of appliances that can be made CC and
Both CC and FIPS give FIPS compliant, see the Common Criteria and FIPS Compliant Appliances section in the Infoblox NIOS 8.5 Documentation.
assurance that the product satisfies a set of internationally recognized security measures. CC is a set of rules and specifications to evaluate the security of
Information Technology (IT) products. FIPS is a U.S government computer security standard that is designed to validate product modules that use
cryptography. This is necessary to maintain the integrity and confidentiality of the end-user information that is stored, processed, and transferred by the
product module. To ensure that your appliance is CC and FIPS compliant, make sure that your hardware and software settings match the evaluated
configuration that was certified for both CC and FIPS. For information about how to configure CC and FIPS, refer to the .Infoblox NIOS Administrator Guide
Infoblox provides tamper evident FIPS labels that you must affix on the HDD cover, all PSU and fan canisters, over the IPMI port of the appliance to make
it FIPS compliant. You must install the FIPS tamper evident labels correctly onto the device for compliance with FIPS. This label is valid for Trinzic TE-
2225 appliances only. Note that these labels are not required for CC.
Clean the chassis before affixing tamper evident FIPS labels. Apply these labels as shown in the figures below:
FIPS label
Install a sticker on the drive bay cover as shown in the picture
To Next Page
Loading...
Need help?
General