What to do if only start up screen appears on InFocus IN2112 Projector?
If your InFocus Projector only shows the start-up screen, press the Source button, activate the laptop’s external port, or restart your laptop.
How to center image on InFocus Projector?
To center the image on the screen with your InFocus Projector, move the projector and adjust the zoom.
How to show Desktop icons on InFocus Projector?
If your InFocus Projector displays only your laptop's background without the Desktop icons, disable the 'Extend my Windows Desktop' option. You can find this setting in Control Panel > Display > Settings > Display 2 (location varies by operating system). Uncheck this option, then click Apply.
Why is the image fuzzy or cropped on my InFocus IN2112?
If your InFocus Projector displays a fuzzy or cropped image, set your computer’s display resolution to the native resolution of the projector via Start > Settings > Control Panel > Display > Settings tab. If you are using a laptop, disable the laptop monitor or turn on dual-display mode.
What to do if InFocus Projector says 'Signal out of range'?
If your InFocus Projector shows 'Signal out of range', press the Auto Image button on the keypad or remote. You may also need to adjust your computer refresh rate by going to Control Panel > Display > Settings > Advanced > Adapter (location varies by operating system). Additionally, try setting a different resolution on your computer.
How to cool down InFocus Projector?
If your InFocus Projector is too hot, make sure the vents aren’t blocked. Turn the projector off and wait one minute, then turn the projector on again. Contact Technical Support if the problem persists.
General| Projection technology | DLP |
|---|---|
| Contrast ratio (typical) | 2100:1 |
| Projector native resolution | SVGA (800x600) |
| Aspect ratio | 4:3, 5:4, 16:9 |
| Power supply | 288 W |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 116.8 x 241.3 x 315 mm |
| Power requirements | 100 - 240 V 50 - 60 Hz |
| Lamp power | 185 W |
| Light source type | Lamp |
| Service life of light source | 3000 h |
| Service life of light source (economic mode) | 4000 h |
| RMS rated power | 10 W |
| Number of built-in speakers | 2 |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Product type | Standard throw projector |
Weight and Dimensions| Weight | 3180 g |
|---|
To Next Page
