InFocus IN5142 - Page 117

73
OPTION menu
Item Description
SERVICE
(continued)
COMMUNICATION
(continued)
SERIAL SETTINGS
Select the
CONTROL
port serial communication
settings.
BAUD RATE
4800bps
ó
9600bps
ó
19200bps
ó
38400bps
PARITY
NONE
ó
ODD
ó
EVEN
• When the COMMUNICATION TYPE is OFF
(

72
), the BAUD RATE is set to 19200bps and
PARITY is set NONE .
TRANSMISSION METHOD
Select the NETWORK BRIDGE communication
transmission method for the
CONTROL
port.
HALF-DUPLEX
ó
FULL-DUPLEX
HALF-DUPLEX: This method allows the projector
to communicate both ways, but only in one
direction, either transmitting or receiving, at a
time.
FULL-DUPLEX: This method allows the projector
to communicate both ways, transmitting and
receiving data simultaneously.
• HALF-DUPLEX is the default setting.
• If you select HALF-DUPLEX, check the
RESPONSE LIMIT TIME (

74
) setting.
(continued on next page)