21
Troubleshooting
English
Try performing the following steps, which can return the projector to normal operation.
1. Press the [ ] (power) key to turn off the projector.
2. After the projector’s cool down is finished and the fan is completely stopped, unplug the
AC power cord.
3. Plug the power cord back in and turn the projector back on again.
* If the power off confirmation message does not appear when you press the [ ]
(power) key, unplug the AC power cord and wait for at least 10 minutes. Then plug
the power cord back in and turn the projector back on again.
The message “It is
time to replace the
lamp.” is being
projected.
It is time to replace the lamp.
➔ Replace the lamp (see “Replacing the Lamp”).
Reference
Guide
(CD-ROM)
The message “The
lamp has exceeded
its service life!.” is
being projected.
The allowable life for the lamp has been exceeded,
and the projector will not turn on.
➔ Replace the lamp (see “Replacing the Lamp”).
Reference
Guide
(CD-ROM)
Problem Cause and Recommended Action See
Infocus IN15_UG_E.book Page 21 Tuesday, October 23, 2007 5:37 PM
To Next Page
Loading...
Need help?
General
