General Guide
6
Before you can use the remote controller for the first time, you need to load the battery that
comes with it.
Replacing the Remote Controller Battery
Caution
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Caution
Misuse of a battery can cause it to leak and stain the area around it, or to
explode, creating the risk of fire and personal injury. Make sure that you
always observe the following precautions.
z Take care that the battery is oriented correctly when you load it.
z Use only battery type that is specified for use with the remote controller.
1. Hook your fingernail on the groove of
the battery holder on the back of the
remote controller. While holding down
the release on the side (
), pull out
the holder (
).
2. Place the battery (CR2025) onto the
battery holder.
z Make sure that the plus (+) side of the
battery is facing upwards (so you can
see it). Take care that you do not
install the battery upside down.
3. Replace the battery holder back into the remote controller.
2
1
Infocus IN15_UG_E.book Page 6 Tuesday, October 23, 2007 5:37 PM
To Next Page
Loading...
Need help?
General
