Infomir MAG544w3 User Manual

13
Using the Remote Control
MiniFusion Remote Control
This section explains how to unpack Remote Control (RC)
and prepare it for work. Your service provider can supply
theproduct with an alternative RC. In that case please refer to
the manual supplied by your service provider. Remote Control
requires two batteries type AAA, R03, LR03, UM-4, 286.
The MAG544, MAG544w3 package includes a remote control
with a block of ve programmable buttons (marked with
blue print colour). You may want to choose these buttons
forcontrolling other devices (your TV set or amplier).
To program the buttons, do the following:
1. Place infrared LEDs of both Remote Controls (STB RC and TV
RC) opposite each other at a maximum distance of 5cm (2’’).
2. On the STB RC, press the “Red”
and “Blue” buttons
of ‘Additional functions’ at the same time and hold them
together for 3 seconds. Access to the setup is conrmed
when the visual LEDs under “TV power” button (Green)
and “STB power” button (Red) turn ON and remain ON.
3. On the STB RC, press the button that will store the copied
data, the LED under “STB power”
button will blink once
and remains ON, to indicate selection of allowed button.
Programmable buttons are marked with blue print colour.
4. On the TV RC, press the button, whose function you wish
to copy to the STB remote. Hold the button until the LED
under the “TV Power”
button (Green) on STB RC blinks
twice to indicate successful operation. Both visual LEDs
remain ON.
5. The STB RС will continue in the copying setup mode
andwill wait for the user’s input to other STB remote
buttons according to steps 3 and 4.
6. To nish the copying process, press the “OK”
OK
button
onthe STB RC. Both LEDs will double blink and turn OFF.
Reset
Make sure RC is in idle mode (no IR-transmission or visual
activity). Press “SETUP” and “OK”
OK
buttons at the same
time and hold up (about 2 seconds) until the visual LEDs
under “T V Power” button (Green) and “STB Power”
button (Red) turn ON. Then, release both pressed buttons –
the LEDs will turn OFF in 1 second. Reset is done.
Important information about using batteries
Do not mix dierent types of battery or old and new batteries.
Do not use rechargeable batteries with the remote control.
Remove the batteries from the remote control if you are not
going to use it for several weeks, to avoid the risk of leakage.
Please respect your environment and any local regulations
and dispose of old batteries in a responsible manner.
CAUTION! DO NOT ATTEMPT TO RECHARGE THE BATTERIES.
IMMEDIATELY REMOVE ANY LEAKING BATTERIES. TAKE CARE
WHEN HANDLING LEAKING BATTERIES AS THEY MAY CAUSE
BURNSTOTHESKIN OR EYES, OR OTHER PHYSICAL INJURIES.

Infomir MAG544w3 Specifications

General

Brand	Infomir
Model	MAG544w3
Category	Set-top boxes
Language	English