Infortrend EonStor DS S12 Series - Page 36

EonStor DS S12/S16/S24 Series Hardware Manual
S16S-R224
2-4 6Gb/s + 1Gb/s Dual Default Default
S24S-G2240 6Gb/s Single Optional Optional
S24S-G2240-4 6Gb/s Single Optional Optional
iSCSI Host
Model name Speed Controller BBU FBM
S12E-G1140 1Gb/s Single Optional Optional
S12E-R1140-4 1Gb/s Dual Default Optional
S12E-G2140 1Gb/s Single Optional Optional
S12E-R2140 1Gb/s Dual Default Optional
S12E-G2140-4 1Gb/s Single Optional Optional
S16E-G1140 1Gb/s Single Optional Optional
S16E-R1140-4 1Gb/s Dual Default Optional
S16E-G2142 1Gb/s Single Optional Optional
S16E-R2142 1Gb/s Dual Default Optional
S16E-G2240 10Gb/s Single Optional Optional
S16E-R2240 10Gb/s Dual Default Optional
S24E-G2142 1Gb/s Single Optional Optional
The BBU is only charged partially when shipped. Therefore, after powering on the
subsystem the BBU will start charging to its full capacity. It normally requires
approximately twelve hours for the battery to be fully charged. If the battery is not
fully charged after twelve hours, there may be a problem with the BBU and you
should contact your subsystem vendor immediately. You can also check the status of
the battery module via SANWatch or the firmware.
36