EonStor DS S12/S16/S24 Series Hardware Manual
For JBODs S12S-J1
000G and S16S-J1000R/S
RAID Models JBOD Configuration
S12E-G1140
S12F-G1440
S12F-G1842
S12S-J1000-G Single-controller; single path
S16E-G1140
S16F-G1440
S16F-G1840
S24F-G1440
S24F-G1840
S16S-J1000-S Single-controller; single path
S16F-R1440
S16F-R1840
S24F-R1440
S24F-R1840
S16S-J1000-R Dual-controller; fault-tolerant paths
There is a rotary ID switch on every expansion enclosure that is manually configured
using a flat blade screwdriver.
Configuring enclosure IDs:
The configurable IDs for JBODs are from 1 to 6. Usually the numbering starts
from the one closest to the managing RAID enclosure.
The S12/S16/S24 RAID subsystems described in this manual connect to a
maximum of 6 JBODs.
Make sure a unique ID is configured on each JBOD so that the SAS WWN
addresses of disk drives can be properly assigned. RAID system firmware
automatically manages these addresses.
91
To Next Page
Loading...