INFOSEC UPS SYSTEM E3 LCD RT IEC 800 - Powering On and Software Installation; Internal Battery Replacement Guide

INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 10 10 AA 59 203 03
8
 Step 7 - Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect
full battery run capability during this initial charge period.
 Step 8 - Install software
For optimal computer system protection, refer to the InfoPower software CD to fully
configure UPS shutdown.
2.4 Battery replacement
NOTICE: This UPS is equipped with internal batteries and user can replace the batteries
without shutting down the UPS or connected loads (hot-swappable battery design).
Replacement is a safe procedure, isolated from electrical hazards.
CAUTION! Consider all warnings, cautions, and notes before replacing batteries.
Note: Upon battery disconnection, equipment is not protected from power outages.
 Step 1  Step 2  Step 3
Remove front panel. Disconnect battery wires.
Pull out the battery box by
removing two screws on the
front panel.
 Step 4  Step 5  Step 6
Remove the top cover of
battery box and replace the
inside batteries.
After replacing the
batteries, put the battery
box back to original
location and screw it
tightly.
Re-connect the battery wires.
 Step 7
Put the front panel back to the unit.