INFOSEC UPS SYSTEM E3 LCD RT IEC 800 - Operations; UPS Control Panel Buttons

INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 10 10 AA 59 203 03
9
3. OPERATIONS
3.1 Buttons operation
Buttons Functions
ON/MUTE button
 Turn on the UPS: Press and hold ON/MUTE button for at least 2
seconds to turn on the UPS.
 Mute the alarm: When the UPS is turned on in battery mode, press and
hold this button for at least 5 seconds to disable or enable the alarm
system. This is not applied to the situations when warnings or errors
occur.
 Up selection key: Press this button to display previous selection in UPS
setting mode.
 Switch to UPS self-test mode: Press and hold ON/MUTE buttons for 5
seconds to enter UPS self-testing while in AC mode.
OFF/ENTER
button
 Turn off the UPS: Press and hold this button at least 2 seconds to turn
off the UPS.
 Confirm selection key: Press this button to confirm selection in UPS
setting mode.
SELECT button
 Switch LCD message: Press this button to change the LCD message
for input voltage, input frequency, battery voltage, output voltage and
output frequency.
 Setting mode: Press and hold this button for 5 seconds to enter UPS
setting mode only when UPS is off.
 Down election key: Press this button to display next selection in UPS
setting mode.