Need help?Do you have a question about the INFOSEC UPS SYSTEM E3 PERFORMANCE RT Series and is the answer not in the manual?
General| Transfer Time | 0 ms |
|---|---|
| Input Voltage | 230 V |
| Output Voltage | 230 V |
| Frequency | 50/60 Hz |
| Topology | Online Double Conversion |
| Efficiency | Up to 95% |
| Waveform | Sinewave |
| Battery Type | Sealed lead acid maintenance free |
| Communication Ports | USB, RS232, Smart Slot |
| Display | LCD |
Guidance on how to transport the UPS system to protect it from damage.
Instructions for preparing and installing the UPS, including environmental considerations.
Precautions and warnings related to potential electric shock hazards from the UPS.
Requirements for installing the UPS with building wiring terminals.
Guidelines for connecting devices to the UPS, including load limits.
Information and safety precautions regarding the UPS batteries.
Information required when contacting the after-sales department for support.
Explanation of the CE logo and compliance with EMC and LVD standards.
FCC compliance information specific to 110/120 VAC UPS systems.
Illustration and explanation of the front panel components of the UPS.
Diagrams and labeling of rear panel connectors for various UPS models.
Step-by-step instructions for physically installing the UPS unit.
Procedure for installing the UPS in a rack.
Procedure for installing the UPS in a vertical tower configuration.
Initial steps for setting up the UPS, including input connection.
Connecting devices to the UPS's programmable and general outlets.
Connecting the UPS to a PC via USB or RS-232 for monitoring and control.
Using the UPS for surge protection on network, fax, or phone lines.
Instructions on how to configure the Emergency Power Off (EPO) function.
Connecting optional external battery boxes for extended backup time.
Procedure for powering on the UPS unit.
Instructions for installing the UPS management software.
Procedure for replacing the UPS internal batteries.
Explanation of the function of each button on the UPS control panel.
Overview of the LCD panel display for Rack and Tower configurations.
Details of the LCD display layout for the rack-mounted UPS.
Details of the LCD display layout for the tower-mounted UPS.
Explanation of LCD displays for backup time, battery status, and UPS operational status.
Explanation of LCD displays for warnings, faults, settings, I/O, and load information.
Description of audible alarm sounds and their meanings.
Glossary of abbreviations and their meanings displayed on the LCD.
Explanation of different UPS operating modes (ECO, Boost, Buck, Battery).
List of fault codes, their meanings, and associated icons.
Description of warning indicators, flashing icons, and alarm sounds.
Procedure to set the output voltage for different UPS models.
How to enable or disable the programmable outlets on the UPS.
Setting backup time limits for non-critical loads on programmable outlets.
Adjusting the maximum battery charger current.
Configuring the LCD display orientation (horizontal or vertical).
Setting backup time limits for general outlets on battery mode.
Inputting the total battery capacity (AH) of the UPS.
Configuring the logic for the Dry Contact EPO function.
Information on non-user-serviceable parts and battery replacement.
Guidelines for storing the UPS, including recharge frequency and duration.
List of optional accessories and their reference numbers.
To Next Page