Why is my INFOSEC UPS alarm beeping continuously?
If your INFOSEC UPS alarm is continuously sounding when the mains power is normal, it could be due to an overload. Check that the load matches the UPS capability as outlined in the specifications. If the load is appropriate, the UPS may be faulty and should be returned to a service center.
What to do if my INFOSEC UPS is on battery mode when mains is normal?
If your INFOSEC UPS unit is operating in battery mode even when the mains power is normal, ensure the power cord is properly connected. Also, check the thermic fuse and press it if necessary.
Why is the backup time shortened on my INFOSEC UPS?
If the backup time of your INFOSEC UPS is shortened during a power failure, it could be due to several reasons. First, the UPS might be overloaded, so remove some non-critical load. Second, the battery voltage might be too low; in this case, charge the battery for at least 8 hours. Finally, the battery may be defective due to a high-temperature operating environment or improper use. If that's the case, replace it with the same type of battery.
General| Apparent Power | 400 VA |
|---|---|
| Output Power | 240 W |
| Nominal Input Voltage | 230 V |
| Output Voltage | 230 V |
| Communication Interface | USB |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Frequency | 50/60 Hz |
| Battery Type | Sealed lead-acid |
Warns about hazardous voltages, user repair limitations, and qualified technician requirements.
Advises on battery handling, replacement by qualified technicians, and disposal precautions.
Explains the meaning of the green and red indicator lights for UPS status.
Guidance on charging the UPS battery before first use and automatic charging.
Steps for connecting the UPS to the power supply and connected equipment.
To Next Page