ELECTRICAL SAFETY
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your INGCO tool is double insulated in
accordance with EN 60745 ; therefore
no earth wire is required.
REPLACING/
INSERTING THE SAW
BLADE
When mounting the saw blade,
wear protective gloves. Danger of
injury when touching the saw blade.
When changing the saw blade,
take care that the saw blade
holder is free of material residue,
e. g. wood or metal shavings.
INSERTING THE SAW BLADE
•
Turn the locking sleeve 4 approx. 90° in the
direction of the arrow and hold. Push the saw
blade into the saw blade holder. Release the
locking sleeve 4 again.
CHECK THE TIGHT SEATING OF THE SAW
BLADE.
•
loose saw blade can fall out and lead to injuries.
For certain work, the saw blade can also be turned
through 180°(with the teeth pointed upwards) and
re-inserted again.
REMOVING THE SAW BLADE
•
Turn the locking sleeve 4 approx. 90°in the
direction of the arrow and hold. Remove the saw
blade .
DUST/CHIP EXTRACTION
•
Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one’s health.Touching or
breathing-in the dusts can cause allergic reactions
and/or lead to respiratory infections of the user or
bystanders.
•
Certain dusts, such as oak or beech dust,
are considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
--- Provide for good ventilation of the working
place.
--- It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your country
for the materials to be worked.
•
Prevent dust accumulation at the
workplace.
Dusts can easily ignite.
INSTRUCTIONS FOR
USE
Always observe the safety
instructions and applicable
regulations.
Observe correct mains voltage!The
voltage of the power source must
agree with the voltage specified on
the nameplate of the machine.
PIVOTING AND RETRACTABLE FOOTPLATE
• Due to its movability, the adjustable footplate
adapts to the required angular position of the
surface.
•
Depending on the saw blade being used and the
application, the footplate can be moved in length
way direction in three steps. Press the release
button for the footplate and slide the footplate
To Next Page
Loading...
