Ingco RS8008 - EC-DECLARATION OF CONFORMITY

8|English
to the required position. Release the footplate
release button and check that the footplate is
firmly latched. Slide the footplate as required until
it is firmly latched.
SWITCHING ON AND OFF
Stainless steel
Plastics
Aluminum
Mild steel
Autoclaved lightweight
concrete
Wood
NOTE:
• If the tool is operated continuously at low
speeds for a long period of time, the operation
life of the motor will be reduced.
• The speed adjusting dial can be turned only as
far as full speed and lowest speed. Do not force
it past full speed or lowest speed, or the speed
adjusting function may no longer work.
EC-DECLARATION OF
CONFORMITY
• The strokes per minute can be adjusted just
by turning the adjusting dial.This can be done
even while the tool is running.The dial is marked
lowest speed to full speed.Turn the
adjusting dial without positive stops between
lowest speed and full speed according to your
work.
• Refer to the table to select the proper speed for
the workpiece to be cut. However, the appropriate
speed may differ with the type or thickness of the
workpieces. In general, higher speed will allow
you to cut workpieces faster but the service life of
the blade will be reduced.
INGCO declares that these power tools
have been designed in compliance with:
2006/42/EC , 2004/108/EC,
EN60745-1,
EN60745-2-11,
EN55014-1,
EN55014-2,
EN61000-3-2,
EN61000-3-3.
• To start the machine, press the On/Off switch
and
keep it pressed.To lock the pressed
On/Off
switch,
press the lock-on button.
•
To switch off the machine, release the On/
Off
switch or when it is locked with the lock-on
button,
briefly press the On/Off switch and
then
release
it.
SPEED ADJUSTING DIAL
picture4