Ingenico iCT220 Initial Setup

Sircle POS
Ingenico iCT220
Initial Setup of the iCT220
• Plug the power cable from the device into the network hub, then plug the
network hub into a power outlet.
• Plug an Ethernet cord into the network hub where its labeled “ETH”.
• Once the device powers on click “F” on the device to bring up the “Telium
Manager”.
• Enter your stock password which should be 1234567 and the “F” key.
• Click 0, 2, 4, 1, 1, scroll down to “hardware infos” then click “Ethernet”. Write
down your IP address since we will be using this later for the Sircle POS setup.
Page 1 of 3

Ingenico iCT220 Specifications

General

Weight	325 g
Display	128 x 64 pixels
Connectivity	Ethernet
Card Readers	Magnetic stripe
Security	PCI PTS 3.x certified
Processor	ARM9 32-bit RISC processor