Version 1.0 (Issued) Page 2 of 5
Introduction
Please follow these instructions to replace the Ingenico iPP350 card reader cable to
the new generation cable; total upgrade time per unit is approximately 2 minutes.
Important
Make sure that you have disconnected the power cord from com port 5 under the unit
before you start.
Step By Step Installation Instructions
Please follow these instruction to change your card reader cable.
1. Disconnect the card reader cable from the com port under the POS (Till) unit first
2. Once disconnected the card reader will lose power, it is now safe to carry on
3. New Ingenico card reader
4. Turn the card reader over
To Next Page
Loading...
