DOCUMENT D’EXECUTION
INGENICO_TD.ai
INFORMATIONS GENERALESCOULEURS UTILISEES APPROBATION
Client: INGENICO
Date : 10 DEC 2013
Utilisation: Impression en tons
directs.
Ne pas utiliser pour application
écran.
7540 C1795 C
GETTING STARTED
Power
Socket
Telephone
Socket
(Modem)
Base
Cover
Ethernet
Socket
Connecting the Base Unit
Release
Clips
1. Remove the base unit cover by pushing the
release clips as shown.
2. Connect telephone cable to socket marked ‘IN’.
3. Connect Ethernet Cable into Ethernet Socket at
back of base.
4. Connect the other end of the telephone cable to a
telephone wall socket or telephone extension cable.
5. Connect the other end of the Ethernet cable to a
router or wall mounted Ethernet socket.
PLEASE NOTE: GPRS (Mobile) terminals do NOT
have any cables. There is only a Power Supply and
a charging base.
6. Finally, connect the Power Supply Unit jack plug
into the power socket on the base unit and then
insert the mains plug into a suitable mains power
socket and switch on the power.
7. Place the Handset onto the base.
PLEASE NOTE: In order to complete the installation you will require your Merchant ID. This will
be included in your welcome letter from your terminal provider.
To Next Page
Need help?
General
