To download a detailed User Guide for the iWL200 Series visit www.ingenico.co.uk/userguides
Frequently Asked Questions, including advice on installation, are available at www.ingenico.co.uk/faqs
ONLINE RESOURCES
REPLACING THE PAPER ROLL
1. Hold the terminal rmly.
2. Open the paper roll compartment by hooking your ngertips
under the ap at the rear of the terminal and gently lift away from
the terminal body.
3. Remove the paper roll or used spool from the compartment.
4. Un-wrap the silver foil from the paper roll or un-stick the end of
the paper roll if it is not wrapped in foil.
5. Place the paper roll into the compartment with the loop at the
bottom.
6. Ensure that the paper roll end is at the front of the compartment.
7. Lift the compartment lid forward whilst holding the top of the
paper roll.
8. Ensure that the paper roll end is outside the compartment and
gently close the lid trapping the paper roll between the rollers.
9. While on the idle screen press and hold the yellow CLEAR key
to ensure that the paper feeds correctly.
DIV434729C
COPYRIGHT © 2014 Ingenico UK Ltd
ALL RIGHTS RESERVED
Date: September 2016
ONLY OPEN THE PRINTER COVER AS SHOWN, DO NOT FORCE THE PRINTER COVER
To Previous Page
Loading...
Need help?
General
