Ingenico iWL220 BT Series - Base Communication Setup; Establish Communication Connection; Charging and Communication Base; Placing Terminal on Base

Inserng the paper roll
OR
Telephone
Power
Charging/Communicaon Base
Ethernet
Power Connecon
(Power should be connected aer communicaon connecon)
(Paper roll must feed as shown)
(Place the terminal on the base to charge)
Base Communicaon
(From the base, establish the communicaon connecon)
*8 hours of charging is recommended daily
Inserng the paper roll
OR
Telephone
Power
Charging/Communicaon Base
Ethernet
Power Connecon
(Power should be connected aer communicaon connecon)
(Paper roll must feed as shown)
(Place the terminal on the base to charge)
Base Communicaon
(From the base, establish the communicaon connecon)
*8 hours of charging is recommended daily
Inserng the paper roll
OR
Telephone
Power
Charging/Communicaon Base
Ethernet
Power Connecon
(Power should be connected aer communicaon connecon)
(Paper roll must feed as shown)
(Place the terminal on the base to charge)
Base Communicaon
(From the base, establish the communicaon connecon)
*8 hours of charging is recommended daily
Port
Inserng the paper roll
OR
Telephone (IN)
Router
Power
Hardware Installaon
Ethernet (ETH)
IN
EMV Chip Reader
(See back for more informaon)
Installing the Pin pad
(Pin pad must be installed before the power is connected)
Pin pad connecon
(USB HOST)
Pin pad
ETH
(Paper roll must feed as shown)
(Terminal & Magic Box should come pre-connected)
Magic Box
EMV Chip Reader
(See back for more informaon)
Port
Inserng the paper roll
OR
Telephone (IN)
Router
Power
Hardware Installaon
Ethernet (ETH)
IN
EMV Chip Reader
(See back for more informaon)
Installing the Pin pad
(Pin pad must be installed before the power is connected)
Pin pad connecon
(USB HOST)
Pin pad
ETH
(Paper roll must feed as shown)
(Terminal & Magic Box should come pre-connected)
Magic Box
EMV Chip Reader
(See back for more informaon)
BASE COMMUNICATION
(From the base, establish the communication connection)
POWER CONNECTION
(Power should be connected after communication connection)
CHARGING/COMMUNICATION BASE
(Place the terminal on the base to charge)
INSERTING THE PAPER ROLL
(Paper roll must feed as shown)
or
8-12 hours of charging is
recommended daily