21
Unlock the connector
by pressing the locking
mechanism as indicated by
F1 arrow while pulling this
connector (F2 arrow ).
Release traction on it as
soon as the connector
comes unclipped.
Finish extracting
connector by tilting it
slightly (F3 arrow) to
bring it away from the
terminal housing.
Inform the terminal that battery will be replaced (*). Do
so start the terminal without battery by tting it on its
base, or connecting terminal power supply.
a
b
Remove terminal from base or disconnect terminal
power supply
Connect and install the new battery by following the
instructions in section 4.5.2 “Installing battery”
Close the battery trapdoor and charge the new battery.
See section “0 “Charging the Battery”
Lift the battery and remove it from its compartment
Carefully disconnect battery, following the instructions
below.
In order to preserve the environnement, dispose used
battery in compliance with current country recycling
legislation.
(*)The terminal memorizes that there is no battery simply
by powering up. It will then correctly perform-full recharge
with the next battery.
To Next Page
Loading...
