23
5_1_2 Base downside connections
Connect all downside
connections
Use “path for wires” to
manage cable exit
Close trapdoor
Remove base trapdoor
pushing on clips shown by
arrows on the picture
B
G
H
Serial link COM1 – RS232
(optional) RJ11
G
Modem socket (optional)
H
Serial link COM2 RS232
(optional)
Path for
wires
Follow the below instructions:
Connect the power supply unit after all other
connections.
Connect the power supply unit to the base
socket B.
Connect the power supply unit to the mains.
To Next Page
Loading...
