INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET - BRYAN, OHIO 43506
(800) 495-0276
FAX (800) 892-6276
© 2020 CCN 99449712
arozone.com
OPERATOR’S MANUAL 66605X-X
INCLUDING: OPERATION, INSTALLATION AND MAINTENANCE
RELEASED: 4-15-87
REVISED: 6-26-20
(REV: AV)
1/2” DIAPHRAGM PUMP
1:1 RATIO (NON-METALLIC)
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
SERVICE KITS
Refer to “Model Description Chart” to match the pump material options.
637140-XX for Fluid Section repair (see page 4).
637141 for Air Section repair (see page 6)
.
PUMP DATA
Models ....... see Model Description Chart for “-XXX”.
Pump Type .... Non-Metallic Air Operated Double Diaphragm
Material ...... see Model Description Chart.
Weight . . .Polypropylene. . . . . . . . . . . . . . . . . .7.2 lbs (3.3 kgs)
Groundable Acetal . . . . . . . . . . . . . 8.8 lbs (4.0 kgs)
Kynar
®
PVDF . . . . . . . . . . . . . . . . . . . 9.5 lbs (4.3 kgs)
Maximum Air Inlet Pressure. . . . . . . . . . . . . 100 psig (6.9 bar)
Maximum Material Inlet Pressure . . . . . . . 10 psig (0.69 bar)
Maximum Outlet Pressure. . . . . . . . . . . . . .100 psig (6.9 bar)
Air Consumption. . . . . . . . . . . . . . . . . . . . . . 1 c.f.m. / gallon (approx.)
Maximum Flow Rate (Ball) . . . . . . . . . . 13 gpm
(49.2 lpm)
(Duckbill) . . . . . . . 10 gpm (37.9 lpm)
Maximum Particle Size
(Ball)
. . . . . . . . . . . 3/32” dia. (2.4 mm)
(Duckbill). . . . . . . . Fibers
Maximum Temperature Limits
E.P.R ...................... -60 ° to 280 ° F (-51 ° to 138 ° C)
Groundable Acetal ......... -20 ° to 180 ° F (-29 ° to 82 °
C)
Hytrel® ..................... -20 ° to 180 ° F (-29 ° to 82° C)
Neoprene .................. 0 ° to 200 ° F (-18 ° to 93 ° C)
Nitrile ...................... 10 ° to 180 ° F (-12 ° to 82 ° C)
Polypropylene .............. 32 ° to 175 ° F (0 ° to 79 ° C)
Polyurethane ............... -10 ° to 150 ° F (-23 ° to 66 ° C)
Kynar®PVDF ................ 10 ° to 200 ° F (-12 ° to 93 ° C)
Santoprene® ............... -40 ° to 225 ° F (-40 ° to 107 ° C)
PTFE ....................... 40 ° to 225 ° F (4 ° to 107 ° C)
Viton® ...................... -40 ° to 350 ° F (-40 ° to 177 ° C)
Groundable
. . . . . . . . . 666056-X and 66605H-X models only
Dimensional Data
. . . . . . . . . . . . . . . . see page 8
Noise Level @ 70 psig, 60 cpm . . . . . . 71.1 dB(A)
The pump sound pressure levels published here have been updated to an Equivalent Contin-
uous Sound Level (LA
eq
) to meet the intent of ANSI S1.13-1971, CAGI-PNEUROP S5.1 using four
microphone locations.
NOTICE: All possible options are shown in the chart, however, certain combina-
tions may not be recommended, consult a representative or the factory if you
have questions concerning availability.
MODEL DESCRIPTION CHART
66605X-X X X - 04
66605X -X XX
637140
DiaphragmBall
FLUID SECTION SERVICE KITSELECTION
EXAMPLE:MODEL#666053-321
FluidSection Service Kit#637140-21
Seat Material
0-(Duck Bill) 4-Kynar PVDF
2-StainlessSteel 6-Acetal
3-Polypropylene
BallMaterial
(*)Duckbillmodels
1-Neoprene
2-Nitrile A-StainlessSteel
3-Viton C-Neoprene (*)
4-PTFE
5-E.P.R
Diaphragm Material
1-Neoprene
elirtiN-2
lertyH-9notiV-3
4-PTFE/Santoprene
Fluid Caps and ManifoldMaterial
3-Piece Manifold Single Piece Manifold
3-Polypropylene
7-Pure Kynar
Cone Check Flow
04 -Top Discharge
XX
6 - Groundable Acetal H-Groundable Acetal
5-E.P.R
B-Santoprene
8-Polyurethane
8-Polyurethane
D-Nitrile (*)
E-Santoprene
J-Polypropylene
K-Pure Kynar
666053-XXX
666056-XXX
666057-XXX
66605J-XXX
66605H-XXX
66605K-XXX
Figure1
To Next Page
Need help?
General
