10 Configuration
Fire detection and extinguishant system
Pressing one of these buttons will allow you to view the list of the respective elements. The list shows the index,
description and status of each element, by tapping on one of the lines you will be able to program the parameters of the
individual element.
2.5 Resetting factory default data
The resetting of the factory default data and consequent deletion of the
configuration data on the Previdia Compact control panel can be done in
two ways:
• By selecting the Factory data option from the programming menu
(refer to paragraph 2.2).
• Using the buttons available on the plastic support of the electronic
boards, as shown in the figure [A]:
1. Press the FACTORY button.
2. While holding down the FACTORY, button, press the RESET button
then release it.
After confirmation of the request for reset to factory default data, the control panel will carry out the same operations as
at first startup, described at the beginning of this manual.
A progress bar will confirm the ongoing reset of factory data.
A