INIM Electronics Previdia Compact

Configuration manual
System Parameters 17
3.8 Configuring the users
Tapping on the appropriate icon inside the control panel configuration screen accesses the configuration
section of the control panel access codes.
This section provides the list of available codes.
Once a code is selected, you can remove it from the
system by pressing the Delete button.
Instead the Program button will allow you to set its
parameters:
• Description, label that identifies the user and that is
shown in the events it is involved in.
• PIN, 5-figure number that identifies the user,thus allowing
access to the system.
• Type, determines the set of operations the user can
control. The following values are possible (refer to
paragraph 1.4 and the User manual):
- No code, code not enabled to access the system.
- User level, coincides with “Level 2” (authorized user)
- Superuser level, same as the previous one, with the
added possibility of replacing a loop device and
registering control panels to their account with the Inim
Cloud service
- Maintenance operator level, same as the previous level
with the added possibility of stopping the valve pulse
for those models that support extinction functions
- User level, coincides with “Level 3” (authorized user)
Previdia Compact control panels are supplied at default with
the first 4 codes already pre-set:
3.9 Configuring the communicator
To set the network parameters you must first enter the control panel programming phase (paragraph 2.2) and
then tap on the appropriate icon inside the control panel configuration screen.
The boxes marked [A] will allow you to select the
communication channels you want to use:
• Ethernet, for transmission of events with the SIA-IP
protocol over Ethernet cable
• PREVIDIA-C-DIAL, for transmission through the optional
communicator of the Previdia Compact.
If selected, the following channels will also become
available:
• SIM (SIA-IP), for transmission of events with the SIA-IP
protocol over 3G
• SIM (Voice/SMS), for transmission of events with
Contact-ID protocol, of voice messages or SMS texts
over 3G
• PSTN, transmission of events with Contact-ID protocol or
voice messages over the landline
Code number Code type Default PIN
1 User level 00001
2 Superuser level 00002
3 Maintenance level 00003
4 Installer level 00004
5 ... No code /
No. Type Description
1 User level Code 1
2
Superuser level Code 2
3
Maintenance level Code 3
4
Installer level Code 4
5 No code Code 5
6
No code Code 6
Delete Program Esc
Access level:3
Code parameters
Code 2 Description
***** PIN
Esc
User level Type
Set
Access level:3
Ethernet Contacts
PREVIDIA-C-DIAL Actions
SIM (SIA-IP) APN
SIM (voice/SMS)
PSTN Esc
PREVIDIA-C-COM Program Contacts
Access level:3
A
B
C
D