Need help?Do you have a question about the INIM SmartLight Series and is the answer not in the manual?
Provides guidance on regular system testing and important recommendations for optimal performance.
Covers system compliancy standards and critical procedures for safely handling electronic components.
Details the frontplate layout, available commands, and their functions based on access level.
Covers the installation of accessory modules and the process of wall mounting the control panel and repeaters.
Provides instructions for connecting devices to the system's loop circuit, including 2 and 4 wire configurations.
Details the procedure for setting unique addresses for devices connected to the RS485 BUS using DIP switches.
Provides detailed wiring diagrams for connecting the optional gas extinguishant module.
Details the connection of the primary 230 Vac power supply to the system.
Explains the series connection of batteries for the system's secondary power supply.
Procedures to verify wiring integrity and isolation before powering up the system.
Step-by-step guide for powering up the system, including battery connection and initial checks.
Setting up fire detection points, including general parameters like address, device type, and zone assignment.
Configuring parameters for the extinguishant module, such as mask zones, confirmation settings, and timing.
Identifying and resolving common input/output faults such as open circuits and short circuits on terminals.
Troubleshooting various loop faults including short-circuits, open loops, and device communication issues.
Troubleshooting issues related to repeater communication and battery status, including disconnection and low battery.
General| Brand | INIM |
|---|---|
| Model | SmartLight Series |
| Category | Control Panel |
| Language | English |
To Next Page
