Tap “+” or “add device” button in home page of the APP
to add the device.
If the controller is in the normal working state, you can
long press 2 seconds to reset the WIFI. It will enter
the Smartconfig configuration state by default. You can
quickly press to switch the Smartconfig configuration
state and the AP mode. If you change the WIFI state, it
will take about 5 seconds to display the corresponding
LED symbol and state, because of the WIFI module data
processing.
Add device in quick connection:
Plug the device in the socket and make sure that the
device is in the Smartconfig.
configuration state (the LED symbol is flashing, interval
flashing 250ms). Click “Confirm indicator rapidly blink”
and then select Wi-Fi network, enter Wi-Fi password,
click “confirm” to enter connection process.
The device only supports 2.4GHz Wi-Fi router.
5
To Next Page
Loading...
