Inkee Falcon Plus

To Next Page

To Previous Page

Falcon Plus User Manual

1、How to connect to GoPro?

① Gimbal： Continuous and fast "click eight times the power button of the gimbal”.

② GoPro： Need to “Reset the connection”

③ GoPro Hero 5：Connect -> Connect to new device -> GoPro APP

GoPro Hero 6：Connect -> GoPro APP

GoPro Hero 7：Preferences –> Connect -> Wireless connect -> Open ->

Connect to the device -> GoPro APP

GoPro Hero 8：Preferences -> Connect -> Wireless connect -> Connect ->GoPro APP

GoPro Hero9： New device connection: Connect - > Wireless connect -> Open ->

Connect-> GoPro APP

Connected device connection： Connect ->Connect to the device ->GoPro App

GoPro Hero 10：Connect-> Wireless connect -> Open -> Connect to the device->

GoPro Quik APP

④ After successfully connect to the GoPro camera, the connection indicator of the gimbal will

be steady green.

2、Why cannot the gimbal turn on?

It maybe that the power of the gimbal is too low. Please charge for 10 minutes and then turn

it on.

3、The gimbal boots vibrating?

① Check whether the installation is leveled and whether the screws are tightened. If the

screws are not tightened, the gimbal may vibrate.

② If the ﬁrmware is older, please update the ﬁrmware.

4、Why does not it take eﬀect when you press the button to take a picture,

record a video or delay a photo?

Since switching from one mode to another may only trigger the mode switching without

triggering the operation, please press the corresponding mode again to trigger the

operation (for example, switching from the photographing mode to the video mode, the

gimbal only switches to the video mode without performing the video operation, so you

need to press the video button again, GoPro camera can perform recording operation).

5、

What is the reason that the boot is still crooked after the installation

of the gimbal?

① If the installed camera is GoPro hero 8 or GoPro hero 9, it may be caused by the virtual

position of the camera lock, please adjust the position of the camera.

② Connect the gimbal to the Falcon app and perform "static calibration" and "horizontal

calibration".

FAQ

Inkee Falcon Plus - FAQ