15
6.3. Pedal Tightness Adjustment
Riders will feel uncomfortable if the pedals of V8 become loose, and will even fall under severe condition. If the pedals become loose,
please respectively use a M10 Allen driver and a M6 Allen driver to tighten the screws on the axis and on the side edge of the axis. Please
develop a habit of checking all parts of the V8 before using.
6.4. Precautions for Cleaning and Use
·Before cleaning the unicycle, the body shall be shut down. Charging wire shall be pulled up, and the charging port shall be closed. During
rinsing, make sure that water does not flow into the battery-charging port.
·Use a soft cloth dipped with clean water to scrub the outer cover of the V8. Do not use high-pressure water jet to flush the V8.
·The waterproof and dustproof level of the V8 is IP54, which means splash-proof and dustproof. Therefore, it is not allowed to dip the V8
in water, which may cause permanent damage to the unicycle.
·Please do not drive in the rainstorm, so as not to fall down or cause damages to the unicycle because of being soaked in the water.
·Please do not place the V8 near the fire source or the places with extremely high temperature, so as to avoid battery damages even
explosion caused by hidden fire-fighting dangers.
*UTUZINGXMKHKRU]ȭ
6RGIKZNK[TOI_IRKOTG]GXSKT\OXUTSKTZȭdȭLUXINGXMOTM
Fully charge the INMOTION SCV before storage to prevent overcurrent
release.
Ensure to fully charge the INMOTION SCV at least once a month.
If you hear the alarm sound when riding in a cold environment, please
place the INMOTION SCV in a warm environment for at least 30min
before riding it again.
Place the unicycle in a safe environment.
:NKYZUXGMKZKSVKXGZ[XKOYY[MMKYZKJZUHKTUZRU]KXZNGTȭGTJTUZ
NOMNKXZNGTȭ
To Next Page
Loading...
Need help?
General
