—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
the user is encouraged to try to correct the interference by one or more of the following measures:
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .
and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
To Next Page
Loading...
Need help?
General
