Charging process
Charging process
The charging process consists of connecting your vehicle to the eBox, authenticating the charging process, charging your vehicle
and finally disconnecting your vehicle from the eBox. Please make sure to carefully stow away any firmly connected cables after use
(steps 1 and 2 are interchangeable).
03
Shortly after successful
authentication, the LED ring
will begin to pulse blue and your
vehicle will charge. After 10 seconds,
the authentication LED turns on
again. To save power, the ring is
switched off after a few minutes
when you move away from the
eBox.
01
Connect your electric vehicle to
the eBox. To do this, plug the ca-
ble into the eBox first. Once your
car is successfully connected, the
vehicle LED will turn off and the
LED ring will light up white.
04
The charging process is finished*
when the LED ring lights up white
again. After you have unlocked the
vehicle or the charging process
has ended, remove the charging
cable, which disconnects the eBox
from the vehicle.
* Optionally, the charging process
can also be ended via app (e.g.
eCharge+ app).
02
Authenticate the charging process
via (e.g. eCharge+ app). To do this,
you need the charging point number,
which is located on the front of
the eBox. When authentication-free
charging has been set, charging
starts immediately.
Proper use of charging cables
No charging cables with adapters
of any kind may be used on the
eBox. The use of extension cables
is also not permitted.
To Next Page
Loading...
