Innotech innTOUCH - Programming innTOUCH; Adjusting innTOUCH Time; Adjusting innTOUCH Date; Configure Daylight Savings Time

innTOUCH User Instructions
Page 6 © Mass Electronics Pty Ltd 2011Edition 4.1 dated 19.01.2015
Programming innTOUCH
Access the programming menu from the
default screen by pressing and holding the
Centre Button for 3 seconds and then
follow the steps in the following sections.
Adjust settings using the and buttons.
Adjusting innTOUCH Time
OFF
ON
SET
Rhppm
kWh
%
OFF
ON
SET
Rhppm
kWh
%
Press at the
Clock screen.
Adjust Hour .
Press .
Adjust Minutes .
Press .
Press at the
Time screen.
Adjust Day .
Press .
Adjust Month .
Press .
OFF
ON
SET
Rhppm
kWh
%
OFF
DAY
ON
Rhppm
kWh
%
OFF
ON
Rhppm
kWh
%
Adjust Year .
Press .
Press at the
Date screen.
OFF
ON
SET
Rhppm
kWh
%
Press at the
Clock screen. Press
to display Date.
Adjusting innTOUCH Date
OFF
MONTH
ON START
Rhppm
kWh
%
OFF
MONTH
ON
Rhppm
kWh
%
STOP
OFF
ON
SET
Rhppm
kWh
%
Press . Press
twice.
OFF
MONTH
ON
SET
START STOP
Rhppm
kWh
%
Press .
Select ON or OFF.
OFF
MONTH
ON
START STOP
Rhppm
kWh
%
Press to
turn o.
OFF
ON
START STOP
Rhppm
kWh
%
Press to set
the daylight saving
dates.
OFF
MONTH
ON
START
Rhppm
kWh
%
OFF
DAY
MONTH
ON
START
Rhppm
kWh
%
Adjust start day
with . Press .
Congure Daylight Savings Time
Adjust start month
with . Press .
Adjust stop
occurence with .
Press .
Adjust start
occurence with .
Press .
OFF
DAY
MONTH
ON
Rhppm
kWh
%
STOP
OFF
MONTH
ON
Rhppm
kWh
%
STOP
Adjust stop day
with . Press
.
Adjust stop month
with . Press
.
Add, Edit, Copy & Delete Schedules
OFF
ON
SET
Rhppm
kWh
%
OFF
DAY
ON
Rhppm
kWh
%
OFF
ON
Rhppm
kWh
%
STOP
Add Weekly Schedule
At the Week screen.
Press .
Select Add with .
Press .
OFF
ON
START
Rhppm
kWh
%
Adjust START hour .
Press .
Adjust START mins .
Press .
Adjust STOP hour .
Press .
Adjust STOP mins .
Press to save
and return to the Add
screen or press to
exit without saving.
OFF
ON
Rhppm
kWh
%
Select Day with .
Press .
(if supported)
The schedule block must exist in the conguration of the
MAXIM controller.
If you notice your time setting has changed, it may
have been updated by the central controller.
The date format is DD.MM, corresponds to 26th
April. The time is 24 hour only.
Aer programming your schedule(s), ensure you enable
scheduling by holding the le button.