26
7.2 Main functions
7.2.1 General start-up
Before the activation:
Make sure that the remote control is connected to the
mains.
In case of a master switch on the power supply line,
switch on the system by inserting the switch.
To activate the control
► press the
key
The control turns on.
The text appearing on the display.
7.2.2 Operating mode set-up
to switch the operating mode
► press the
key for about 2 seconds
The symbol on indicates the Heating function
enable
The symbol on indicate the Cooling function en-
able
In heating function the symbols is alight with setpoint
higher than the room temperature.
In cooling function the symbols is alight with setpoint
lower than the room temperature.
In the case of an incorrect setpoint, the symbol of the
appropriate value is reached.
7.2.3 Put in stand-by the control
► press the
key for about 2 seconds
The control goes out.
7.2.4 Set room temperature
► operate the
keys to decrease or increase
the desired value
The displayed value change.
The temperature adjustment range is from 15 to 30°C,
with a resolution of 0.5°C.
except in automatic mode. Only set these values for
short periods.
7.2.5 Setting the ventilation speed
To select the fan speed control
► press the key
The symbol on indicates the Silent function en-
able
The ventilation speed is limited at a more reduced max-
imum value.
► press the
key for about 2 seconds
The symbol
on indicates the Heating function
enable
The symbol on indicate the Cooling function en-
able
In heating function the symbols is alight with setpoint
higher than the room temperature.
In cooling function the symbols is alight with setpoint
lower than the room temperature.
7.2.6 Set the key lock
► press both keys
for 10 seconds
The text
appearing on the display.
All settings are inhibited by the user.
Repeat the sequence to unlock the control.
7.2.7 Brightness reduction
► press the
key for 10 seconds
The text appearing on the display.
► press the
key for 10 seconds
The text appearing on the display.
After 20 seconds from the last action the panel bright-
ness will be reduced to increase the comfort during
night use. On the display will appear only the room
temperature.
7.2.8 Deactivation
► press the key
for about 2 seconds
All the light signals go o.
In stand-by mode, the control guarantees antifreeze
protection.
7.3 Warnings
7.3.1 Long period shut-down
For seasonal shutdowns or for long periods:
► disable the device
►
7.3.2 Visualization of alarms on display
probe disconnected or faulty (automatic reset
alarm)
None of the modes can be activated.
To Next Page