EasyManua.ls Logo

Innova AirLeaf EEB749 - Preliminary Warnings; Routine Maintenance; External Cleaning; Air Intake Filter Cleaning

Innova AirLeaf EEB749
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
MAINTENANCE
MAINTENANCE
Routine maintenance is essential to keep the device always

10.1 Preliminary warnings
Before each cleaning and maintenance intervention:
disconnect the device from the power mains by turn-
ing the system master switch to "OFF"
wait for the components to cool down in order to
avoid any burns
Carrying out any technical or cleaning work before dis-
connecting the unit from the power supply is forbidden.
Make sure that there is no voltage before operating.
After completing the maintenance work, must be re-
stored the original condition.
Warnings:
Do not lean or sit on the fancoil to avoid damaging
the appliance.
Do not manually move the horizontal louver of the
air outlet. Always use the remote control to do this
operation.

immediately and disconnect the power supply. Then,
call the nearest customer service centre.
The device must not be installed in rooms where
there are explosive gases or where there are condi-
tions of humidity and temperature out of the limits


10.2 Routine maintenance
Routine maintenance is essential to keep the device al-

Carry out cleaning:
every six months
Before each cleaning and maintenance intervention:
disconnect the device from the power mains by turn-
ing the system master switch to "OFF"
Wait for the components to cool down in order to avoid
any burns.
After completing the maintenance work, must be re-
stored the original condition.
It is forbidden to open the access doors and carry out
any technical or cleaning intervention, before having
disconnect the device from the mains supply by placing
the main switch of the system on "OFF".
10.2.1 External cleaning
Clean the external surfaces using a soft cloth dampened
with water.
Do not use abrasive sponges or abrasive or corrosive
detergents as you might damage the painted surface.
Disconnect the unit from the power supply before each
cleaning and maintenance intervention by setting the

10.2.2 Airintakeltercleaning

after prolonged operation, considered the concentra-
tion of impurities in the air
when you plan to restart the system after prolungate
disuse

Table of Contents